Date: Sep 21, 2022　Views:
Fault phenomenon
The engine could not be started after the engine was suddenly turned off during operation. The starter motor and engine could rotate, but could not be started.
Failure analysis
The main reasons why the excavator engine cannot be started are the failure of the starting system and the electrical system, the failure of the fuel supply system, and the failure of the compression and lubrication system. The starter motor and flameout motor of the equipment are working normally, which can rule out the problem of start-up and electrical system, so this problem needs to focus on checking the poor supply of fuel oil circuit and the engine compression and lubrication system.
Troubleshooting
1. The fuel supply of the equipment is mainly from the fuel tank through the pipeline connection into the separation and filtration of two oil-water separators, then passes through the third layer of oil-water separators, and then passes through the pressurization of the pump, and finally enters the fourth diesel filter element for filtration. .
2. The maintenance personnel checked the fuel filters and cleaned the internal filter. Checked the oil pipes and joints and found no blockage and leakage.
3. Check the cylinder pressure of the engine, and the pressure values are all within the normal range. Check the ignition timing of the engine, the fuel supply advance angle is normal and there is no problem.
4. The maintenance personnel removed the fuel delivery pipe of the fuel delivery pump, then started the engine and found that the amount of fuel passing through was very small, so they disassembled the fuel delivery pump and found that the slide valve in the fuel delivery pump was stuck, resulting in the fuel supply pump not supplying fuel!
Troubleshooting
After the fuel pump was replaced, the commissioning equipment returned to normal.
cause of issue
Because the oil used by the owner has not been replaced for a long time, there are too many impurities in the oil, which causes the internal spool valve of the oil transfer pump to be stuck.
Summarize
Needless to say about the maintenance of the engine, many people still have luck in their hearts. In the article, the oil is not replaced in time, and the fault is found. It's not because the equipment can't be started, and the machine owner doesn't realize it. If the oil is too dirty for a long time, the engine system is not well lubricated, which will cause the engine to work at high temperature and inefficient, which will seriously cause tile burning and shaft holding. It's too late to regret it!
A warm reminder to all bosses: engine oil must be replaced in time, equipment maintenance must be paid attention to, and you must not be lazy!